Razor E200 Manuel d'utilisateur

Owner’s ManualItem Numbers E100 13100E-BL E125 13125E-BK Black 13111110 RedE150 13111612 E200 13200E-SL E200S 13201S-SL E225S 13112850

9 REPAIR AND MAINTENANCE1 (E100 only, other models go to Step 2) Loosen the brake pad bolt and remove one brake pad.q Front Tire Replacement Tools req

10q Battery Care and Disposal Do not store the battery in temperatures above 75° or below -10° F. CONTAINS SEALED LEAD BATTERY. BATTERY

11 TROUBLESHOOTING GUIDEScooter does not runScooter was running butsuddenly stopped Short run time (less than 30 minutes per charge) Scooter runs sl

12Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Frida

Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifi

E100 PARTS14

E150 PARTSKeep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availabili

E150 PARTS16

Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifi

E200 PARTS18Only used on E200S

WARNING: Riding the E100, E200 or E300 scooter can be a hazardous activity. Certain conditions may cause the equipment to fail without fault

Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifi

E300 PARTS20Only used on E300S

SB 1918 (CALIFORNIA) DECLARATIONYOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO

Tire Inflation Periodically inspect the tires for excess wear, and regularly check the tire pressure and re-inflate as necessary. If you get a flat tire,

ChargerCharger Plug Charger PortRemove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect

3 ASSEMBLY AND SET-UPq Attaching the Handlebars WARNING: Failure to properly tighten the wedge may allow the handlebars to dislodge while riding

q Adjusting the Handlebar Height (E100/E200/E300 only)q Riding Your Scooter Testing the Brakes – To use the brakes, squeeze the front and back brake l

5 REPAIR AND MAINTENANCE1 Use the special valve extender/adapter supplied. The valve adapter is located in the bag with the owners manual supplied at

6 REPAIR AND MAINTENANCE q Adjusting the Chain Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.1 Using two 17mm wrenches

7 REPAIR AND MAINTENANCE q Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm

8 REPAIR AND MAINTENANCE 10 Install the axle adjusters and axle nuts. Tighten until they just barely hold the hardware in place.11 Tighten both axle a